Replacement for Thule bike roof rack carrier tire mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For when your bike tire clamp on the Thule roof bike carrier breaks
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 304
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
The plastic housing of the tire mount on my Thule roof rack broke. This is the printable replacement part.
Instructions for printing:
Depending on your climate, use PETG or something that will handle the expected temps. 0.2 mm layer height worked well for me; more should work too. Supports are needed inside the mounts for the clips, but not elsewhere. The part does not need to be particularly strong; the metal catches on the existing reused parts do most of the work.
Instructions for assembly:
Look at the photos for clarification. The same model applies for the front and rear mounts.
Remove the black front cap from the rail of the roof rack. Save it.
Slide the entire assembly forward off the rail.
Break apart the old plastic part to get the strap and buckle parts. These do most of the work. The strap has a soft protective sleeve: remove it for now.
Push the strap (without the soft protective part) from below into the clip mount on the side with two vertical holes. The catch should be turned inward so it grips the rail when mounted.
Push the strap catch in with some force while pulling on the strap, until the catch seats in the mount and you can't get it out anymore. The two small metal springs on the catch should get stuck in the mount and hold the strap securely. Replace the soft rubber part on the strap.
On the opposite side, slide the buckle in and forcefully seat it in the mount. The same logic as with the strap applies.
Check if both parts are securely attached. You should not be able to get the two parts out of the mounts without breaking something.
Slide the whole assembly on the roof rack rail; the buckle should point outwards. It is a snug fit; you might have to hit it a bit to get it on, depending on the quality of your print and whether the rail is entirely straight. Check if the catches grip the rail correctly. Leave some room for the front cap.
Mount the black front cap of the rail. You are done.
Instructions for use:
Use like the original part.