Integral Mesh Vent Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a vent cover with an integral mesh that can be used for small invertebrate enclosures.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 667
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Share Alike
NOTE:
I've uploaded a newer version that is optimized for semi-flex material, and uses openSCAD, for ease of customization.
https://www.printables.com/model/207250-integral-mesh-vent-cover-v2
---
This is a mesh vent cover that can be used for small invertebrate enclosures. It is intended to be printed with a fine mesh fabric embedded into the ring after the first layer.
Instructions:
After slicing, insert a pause after the first layer. You can do this directly in prusa slicer, or by manually editing the gcode.
Start the print as per normal. Once the first layer has printed, the printer should pause, and you can cut out a piece of the fine mesh fabric, and drape it over the first layer. You can hold the fabric down and stretch it out via magnets, binder clips, tape.. whatever works.
After that, resume the print, and then once it has finished printing, use scissors to cut off the extra fabric outside the ring.
I printed this in PETG, at .2mm layer height. The snaps do have an unsupported overhang, but it's small enough that it seems to print fine even without supports.
For the mesh material, I just cut up some cheap $5-$6 sheer curtains that I bought from my local big retail store.
Note:
This is a fusion 360 script that requires the fscad framework to run. See http://fscad.org