PTFE tube gland guide for drybox and enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A gland / guide / grommet for passing through, and holding, a PTFE tube passing through a drybox or an enclosure
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Here is a little screw together grommet or gland for holding onto a PTFE tube as it passes out of a drybox or through an enclosure. This is sized for 4mm PTFE tube, and a 10mm hole in whatever surface it's passing through, the fit is loose through the fitting but when tightened will clamp the tube in place.
I'll provide a link to the onshape document if you want to resize it or change the tolerances of the holes etc. If you need something like that but can't do it yourself, let me know in a message and I will try to help you out.
Also included is a little nut tool that is handy for tightening "cable nuts" like this one kind of is. Link to that onshape doc also below.
Links:
Thanks!
Update Oct 2026
I have tweaked the thread design so that it prints a little easier.
There are now two versions for different size PTFE tube.
I added a large hole version to allow PTFE tube to slide in and out. I am using this at the top of my enclosure to allow the excess of tubing to slide back up out of the cabinet (rather than bending around inside the enclosure)
The names are in the format PTFE diam, threaded hole diam, hex head diam
eg: Gland Guides - Bolt_4mm_12mm_18mm is for 4mm OD PTFE tube, you need to make a 12mm hole, and need a spanner (or the thread tool provided) of 18mm to tighten.
Note: Ignore the quality of the STEP files in the model viewer, this is an issue with Printables - they will look fine in the slicer.
