KitchenAid Mixer Gearbox gasket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A gasket for KitchenAid mixer gearboxes. Fits a KSM90 and compatible models.
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 182
- Wydruki
- 1
- Wyświetlenia
- 732
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
An STL of the KitchenAid mixer gasket on models like the KSM-90.
CHECK THE MEASUREMENTS BEFORE PRINTING!
It worked as-is on my KSM-90 from 1992, but some folks have reported needing to scale it to 106-107% in the slicer to get a proper fit, so clearly KitchenAid changed the mixer castings over time.
Known models that need scaling - consider leaving a comment if yours does too (or if it doesn't and I'll happily update this list:
5K45SS
5KSM180
Print in flexible filament, I used 3D Solutech's clear flex which (I think) is 92 or 98A. Softer materials like Ninjaflex should also be fine, you need something with a little bit of give to form the seal.
It's been holding up well for several months now in my mixer and it's a lot tougher than the original paper gasket.
(Sorry, no photo because I didn't think to take one and I don't want to take my mixer apart right now and get grease everywhere)