Alinco DR735T mounting for Gen3 Ford Ranger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed a good way to mount an Alinco DR735T into my manual Ranger and this is the best solution I was able to find.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn't realize how few mounting locations there would be for a radio in a manual single cab truck that doesn't take up valuable storage space, so I found that I could remote the radio under the passenger seat and mount the faceplate under the HVAC controls. It is just out of the way enough that the shifter clears it when rowing through the gears but only just, so it's perfect. It makes the controls almost useless when under way unless in 2nd/4th but I'll chalk that up to good engineering to prevent distracted driving.
The radio mount is screwed into the bottom of the black radio bezel and the mic is screwed into the bezel just below the 12v plug since there's not anything too delicate behind it, you could probably also use 3M adhesive or other sort of adhesive to affix it but I don't recommend it as someone who drives on poorly maintained roads. After testing, I'm getting a little vibration issues/noises at idle that I might add a rubber shim or two between the radio and the black radio bezel of the truck to keep that from happening.
Printed in PETG on an Ender 3 v2 and designed in OnShape. I recommend either printing in ABS or PETG for longevity.