Coffee Distributor for Levelling Tamp Base [51mm Dedica Portafitler]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add-on to the "base" print of my guiding tamp model. Distributes coffee easily and evenly for improved tamping
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 317
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This slightly absurd model is intended for use with my already published Levelling Tamper model for the Dedica Espresso machine. (Linked bellow)
The entire thing has been proportioned such that the handle sits flush against the guide when set on a table.
It has a maximum reach of 6mm below the rim of the portafilter
The tolerances for the standard leveller face are quite tight. For easier spinning, use the v2 versions of the Faceplate and Backplate.
The distributor face has been separated into 4 pieces in order to ensure they are as flat and smooth as possible, minimizing the amount of residue and mess.
This does however mean, that you will have to glue the faceplates onto the backplate.
The fitment between the backplate and handle should be tight enough for a friction fit, allowing for easy disassembly
For a complete print, you will need
1x Backplate
3x Faceplate
1x Handle
1x Guide