1 / 6
Filament roller for 1kg up to 8kg rolls — zdjęcie 1
1 / 6

Filament roller for 1kg up to 8kg rolls

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ever wanted to buy the big rolls of filament to save some money, well now you can and this roller helps you.

Ocena
0 / 5
Polubienia
1
Pobrania
13
Wydruki
0
Wyświetlenia
113
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a roller for the big rolls of filament but can also take 1kg rolls too.

The limits are a diameter of 355mm and width of 170mm. The center hole can be as small as 35mm and up to 57mm(using nr 2 roll with support rings).

The print for the legs is a tall one at 228mm so you need to make sure your printer can make it.

I have made two types of roller that you can use to hang the filament. Nr 1 is a plain roller that can take any roll but they are not centered and can give some resistant to the extruder when it swings. Works fine when the center hole on the filament roll is below 40mm. Nr 2 is a roll with supports rings that will center the filament roll on the roller, therefore gives no swing. The downside is that it can only take filament rolls at a maximum width of approximal 130mm.

The hardware need for the print is as follows:

Legs:

2 x threaded rods M5 at 280mm

4 x nuts M5 and washers if you think it needs it

Roller:

4 x 608 bearings

1 x threaded rod M8 at 280mm

4 x M8 ordinary nuts

2 x M8 locknuts

Prints

You need 2 x legs, if you want the plain roller nr 1 then you need no support rings, if you go for nr 2 roller you need 2 x support ring.

Assembly

Legs:

Use the M5 rods and stick it through the base of the legs secure with M5 nuts and washers.

Roller:

Stick the M8 rod through the roller and secure with 2 M8 nuts on each side, put 2 bearings on each side and secure with locknut. You may have to check that the bearings fit in the slots of the legs, otherwise adjust so they do.

If you want to have one roller of each type you need to have the same hardware for roller nr 2 that you hade for roller nr 1. But you need to print the support rings for nr 2 roller.

I made it all in PLA and have had no issues, there is no need for support materiel, except a brim when printing the rollers. The orientation when printing is for the roller standing up, legs standing up and the support ring on it biggest side. The support ring has a rather snug fit on the roller and might need a bit of persuasion in the beginning. 

Enjoy the print and let me know if there is any problems.

Tagi