Playstation 1 Picostation mount using only SD to MicroSD card adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simplified Picostation mount. Only thing needed is sd to microsd card adapter.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 200
- Wydruki
- 0
- Wyświetlenia
- 894
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remember: This model is not intended for the PicoStation PCB, but rather for a PCB-less installation (such as this one: https://www.reddit.com/r/psx/comments/1m4h7i3/wired_no_pcb_picostation_install_on_a_pu18_ps1/). The MicroSD to SD adapter is wired up directly to the Raspberry Pi Pico. There seems to be no need for any resistors or voltage level converters (as Pi Pico and SD cards are both 3.3V)
Print the model vertically so the curved surface for easy microSD card removal is curved. Add pause after the walls around the adapter are printed and insert sd to microsd card adapter into the print. Then resume printing. The model contains access hole to the adapter pins to solder wires later.
The included 3mf file contains all the steps i have listed. It also contains the bottom spacer, which i have also slightly modified (i believe i just cut part of it off in slicer). I also included STEP file.