1 / 3
SCX30 Rear Links  +5mm length with balljoints — zdjęcie 1
1 / 3

SCX30 Rear Links +5mm length with balljoints

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These rear links will increase the wheelbase of your SCX30 by 5mm

Ocena
5 / 5
Polubienia
19
Pobrania
228
Wydruki
1
Wyświetlenia
1179
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

Here are some basic rear links for the SCX30 to increase your wheelbase by 5mm.  These probably wont fit your stock bodies without modification obviously, but can work will on custom and fenderless rear bodies like the one shown (coming soon).   These are slightly larger than stock, mainly because they have to be for an FDM printer.

The easiest way to install ball joints if you havent before, is to use a stock screw or bolt, but it through the balljoint, and then use a small needle nose pliers to push on the bolt, into the link.  The bolt head helps to not deform or destroy the hole of the balljoint.  If you havent done this before, print some extras.

And if you've never printed links before they can be tricky depending on the quality and maintenance state of your printer.  I recommend printing at an angle to help keep the ball sockets round, but you might need to experiment.  I print these on a P1S at 45 degrees (sideways, not vertically) at .08 height.

Tagi