1 / 6
Hydroponics 5 Gallon Bucket Lid for DWC Growing — zdjęcie 1
1 / 6

Hydroponics 5 Gallon Bucket Lid for DWC Growing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Split design bucket collar/cover for Kratky method of growing plants.

Ocena
0 / 5
Polubienia
8
Pobrania
54
Wydruki
0
Wyświetlenia
327
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

These will help solve two of the biggest issues I've run into with the Kratky bucket methods.

  1. No more algae growth, print these in a black filament (or paint them) and they will sufficiently block out all light beneath them

  2. If your buckets are like mine, they have a a tube ring that spouts water into the top of your grow medium, this water tends to spatter everywhere making quite a mess. This will also prevent that mess.

There is a 1.5 inch diameter opening to accommodate just about any stock. With a chamfer on all edges to keep it from cutting into the stem/stock of your plants.

They separate so you can easily put them on or remove them as required no matter what stage of growth your plants are at. They go together with a keyed tab at each end and a lap over to make sure the seam of the joint is still blocking light from getting in and water from getting out.

Basic Print Settings:

Material: I used ABS, but should work fine with PLA or PETG
Layer Height: 0.2mm
Infill: 40% Gyroid
(Reduce light infiltration and give it some additional rigidity)
Top/Bottom Layers: 5
(Additional strength and further reduce light infiltration)

Supports: Tree auto
(The lapover and keys need to be supported)

Tagi