Toyota MR2 Spyder (MR-S) Engine Bay Prop Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Toyota MR2 (00-06) Engine lid prop clip to replace a broken one
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 256
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
For proper use, print with a material with high thermal resistance. ASA, ABS, PETG, etc.
For the SW20, please look at my other models. The size/orientation is a little bit different.
This clip was printed so that the prop rod was oriented in the Z-axis. You will need to trim some plastic and print with supports (only on the build plate). It does latch properly once fully seated, so if you have issues with getting it all the way pushed in, try finding the offending lil nib that will keep it from going all the way down.
Also double check that the hole around the clip was not bent while removing the old clip. You may need to use a large-ish punch to work it back flat.