Top mounted Spool Holder with self centering spool roller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the original model replacing the 'pipe' with a holder for a spool roller with bearings.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 81
- Wydruki
- 2
- Wyświetlenia
- 357
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This remix changes the original 'pipe' component with a hex-ended holder for a self centering spool roller I used in another model. Remix uploaded at the request of another user. Its is hex-ended for obvious reasons - it won't slip :)
Additional hardware:
2 x magnets (6mm x 2mm)
Printing instructions:
Print the strut as described in the original model. Print the spool roller holder with the support pins pointing up. This is a very low stress component, so vertical pins are ok.
The spool holder that fits this model is located here: