1 / 4
Universal tube squeezer, easy to print, easy to assemble, easy to use — zdjęcie 1
1 / 4

Universal tube squeezer, easy to print, easy to assemble, easy to use

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Universal tube squeezer available in six width, usable for all kind of tubes up to a width of 78mm

Ocena
0 / 5
Polubienia
25
Pobrania
114
Wydruki
0
Wyświetlenia
453
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Universal Tube Squeezer, usable for all kind of tubes up to a width of 78mm. 

Available widths (max): 38mm, 46mm, 54mm, 62mm, 70mm, 78mm

The tube squeezer consists of two diffrent parts (roller/connector), easy to print and assemble, easy to use.

Printing recommendations:

  • filament PETG or similar (no brittle filament)

  • 0.4mm nozzle

  • 0.2mm structural

  • 20% infill, Gyroid

  • 3 Perimeters

  • no supports, no brim

print 2 roller and 2 connector for one squeezer

Assembly instruction:

  • take a roller and push a connector fully into the hole at one side of the roller

  • take the second roller and push it onto the other side of the connector

  • pay attention to the parallel alignment of the rollers

  • take the second connector and push it into both holes at the opposit side of the rollers at the same time

  • done, both rollers should turn easily

How to use the Squeezer:

  • Take the tube and measure the width at the tube end. Choose a squeezer which is a little bit wider

  • Slide the squeezer over the end of the tube until the end protrudes far enough to be held.

  • Hold the tube end with one hand and push the squeezer with the other hand (two fingers) into the tube opening direction. The squeezer rolls or slides on the tube.

  • Stop when the contents have been pushed forward sufficiently.

  • Adjust the position as the tube empties

Tagi