Molex MicroFit 3.0 2x3P - Compatible Male Plug

This is intended to be a stop-gap solution for someone (like me) who is too impatient for their proper Molex connectors to arrive! As always please take care when printing for electrical connections such as this and make sure that your chosen filament is appropriate for the job both in terms of temperature but also in suitable for the operating voltage you will be working with. I take no responsibility for any sparks/melting!

Please note that the female connectors should be a tight friction-fit (make sure that this is the case prior to install), but they won't have any real pull-out strength.

Parts Required:

• 6x Molex 43030 Female Crimp Connectors (crimped onto appropriate cables)

Recommended Print Settings (Snapmaker U1):

• 45 degree -ish inclination angle from the horizontal

• 0.08mm layer height

• 0.4mm nozzle (but ideally 0.2mm or 0.15mm!)

• I used PLA but ABS (or similar) is probably more appropriate

• 100% infill (the sliced file should be all-walls in any case)

• Supports everywhere