Tacx Neo additional Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This thing is to help the internal fan of your Tacx Neo (every edition!) to get rid of the heat. After reading so many…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 187
- Wydruki
- 1
- Wyświetlenia
- 1829
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This thing is to help the internal fan of your Tacx Neo (every edition!) to get rid of the heat.
After reading so many complains about overheating Neos I decided to design a fan mount which helps the neo to suck air out of the housing to prevent overheating failures.
o use a 60mm fan
o 2 versions available: with a PWM module (from Amazon) and without
o mount it with M5 screws from the inside out or use tape
o mount the fan so that it sucks (!!!) the heat out of the housing
o if you do not use the 5,5/2,5mm connector close it with the provided plug
o no support material needed
o use double sided tape to mount it on your neo
o use a strong 12V 60mm fan, not a cheap USB powered 5V fan
o you only have a 80mm fan? print this part and a 60 to 80mm fan adapter
o your Neo DC supply runs on 48V, most 60mm fans do need 12V (as mine does...)
If you want me to drink a cup of coffee on your cost please consider to hit the tip button on the top right here on Thingiverse :-)
test if your fan sucks air out
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament: PLA of your choice PLA Black
Category: Sport & Outdoors