Gridfinity 1x1 Tweezers Bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 1x1 Gridfinity-compatible bin for storing tweezers.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 252
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Open Community License v1
Overview:
A 1x1 (height 10*7mm) Gridfinity-compatible bin for storing tweezers. The slots for the tweezers are 12 mm x 5 mm, so they should be compatible with a wide variety of soldering tweezers. In particular, they are compatible with Pixnor tweezers and Multicomp Pro tweezers, but they should work for many others.
If you have a magnetic base, then no additional weight should be needed to allow the base to stay down when pulling out the tweezers. If there is no magnetic base, there is a variant of the model that has a space in the bottom for you to put a weight in. In the photo below, I used a two-part epoxy to glue in a 3/8" in hex nut which provides enough weight.
Print Settings:
The print shown below was done in PETG, with a color change at layer 31 from the top.
Prusa MK4 with Grey and Blue filament
0.15mm Structural settings
15% grid infill
Paint-on supports only in the weight carveout area
Filament used: 51.12 g
Print cost @$23/kg: $1.18 USD