Prusa Core One/+ Squash Ball Feet - Lighter Faster (slighlty) Sturdier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Original design by @dancan13f. Lighter in filament, faster to print, a bit sturdier than the original design.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 281
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A little bit Lighter Faster & Sturdier than the original design :
Kudos to the original designer, do not hesitate to grab him a coffee by tipping him :
https://www.thingiverse.com/dancan13f/designs
I used the 2 yellow-points balls since I think they are the more "dampening" ones.
I wanted to evaluate the efficiency of these feet, so I downloaded 2 torture test designs :
What I did :
- Remade the belts tightening "LED light" procedure (got à 98Hz - 92Hz couple of frequencies), noted my calibrated Input Shaper frequencies : ("MZV 47Hz - ZVD 65Hz" and sometimes "MZV 47Hz - MZV 48Hz");
- Turned off Stealth Mode (it is always ON here...);
- Sliced the two parts (0.2 fast - see picture for parameters) adding a pause at height 6mm;
- Loaded some brand new fresh out of the bag Sunlu Gold PLA+
1) Printed with original Prusa feet, filmed one minute at the restart of the print;
- Mounted the squash feet - LFS on my Core one;
2) Printed with squash feet, and exact same G-Code, filmed one minute at the restart; ("Oh god the printer moves so much on the table, it's gonna fly!")
- Did a whole calibration of stepper motors phase-stepping (84% & 91% vibration reduction) and input shaper (MZV 47Hz - MZV 48Hz) using Prusa Accelerometer;
3) Printed again after calibration, filmed one minute at the restart;
- Aligned the prints and checked the quality with window sunlight : To me they are IDENTICAL (and pretty nice for fast printing)
- Compared the videos : there was in video "1" some "floppy-drive"-like sound on certain movements, that seem to have disappear in video "2" and "3".
So to my conclusions :
- The furniture around the printer moves really less;
- The printer becomes "Winnie the Pooh - Tigger" jumpy-like;
- It seems that some noises are gone in fast - no stealth mode;
- No change at all was observed on the print quality.
I'll see what comes in the next prints in stealth mode, but, it seems like the mod insulates the printer from furniture. So for now, I'll keep it.
(Or maybe I'll try this if I get the BOM for these HULAs :)