10 inch rack mount Ugreen KVM AK500
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this to mount my Ugreen KVM AK500 in my 10 inch mini network rack.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 269
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this to mount my Ugreen KVM AK500 in my 10 inch mini network rack. This was mounted in this rack https://www.printables.com/model/1173696-3d-printable-rack-10-inch-and-6-inch and works well. There is about 5mm of leeway for the KVM to move back and forth, but it slots in through the top-back well and is securely held in place.
I printed this in AnyCubic PLA using an AnyCubic Kobra S1. I used 25% infill density, 3 wall loops, and 5 bottom and top shell layers. No supports or brim needed.
The mount uses 4 m5-80 screws with a 25mm length and 4 m5-80 nuts, per the instructions from the rack print above.