1 / 6
Long G-Scale/Gauge 1 Rerailer - 432mm (17in) — zdjęcie 1
1 / 6

Long G-Scale/Gauge 1 Rerailer - 432mm (17in)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I was unable to find a rerailer for longer G-Scale rolling stock that I liked so I remixed an H0 rerailer for 45mm rails

Ocena
0 / 5
Polubienia
5
Pobrania
58
Wydruki
0
Wyświetlenia
286
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I was unable to find a (re)railer of longer size for my G-Scale trains that I liked. This is a rescaled H0 railer that I shortened and cut to be able to print in only two pieces using the PrusaSlicer cut tool.  I've uploaded the whole railer and the cut version I used for the MK4S with connectors.

Some info, ideas and suggestions for anyone looking to print this:

  1. At ~400 mm the railer is the length of one half of the PIKO Easy Railer, which comes with two pieces each at roughly 16" for a total of ~800mm or 32" when both are in use.  I briefly checked and 800mm would pretty much accommodate the longest G-scale locos out there. 

  2. Printing the parts vertically means that you have a nice slope on the ramp instead of the layered/tiered look you would get from printing the bottom flat on the plate.  I think this looks much nicer.

  3. This limits the length of one of the pieces to the max height of your printer, the MK4S in my case, and I didn't want to deal with more than two pieces so that set my maximum length.

  4. You can change the length by adjusting only the Z direction (do not change X or Y) to your desired final length and splitting the model into whatever height and however many parts you can accommodate.  Don't forget to leave room for the connectors when you make the cut.

  5. I added 4mm depth and size connectors to my print with the default tolerances of (0.1 depth and 0.0 size) but you don't really need the connectors to fit so tightly, especially if you plan to store the railer in parts, instead of as one long piece. I promptly broke one connector off in taking the the railer apart.  I would increase the tolerance but can't say for certain what would be best.  Don't forget to leave room for the connectors in the Z-direction when you make the cut.

  6. Use enforced supports for the diamond piece on that aligns the trucks.  If you auto-generate supports you will add supports in the holes for the connectors (as I did) and these are a pain to remove.

  7. I printed with the PS 0.15 Structural preset and changed infill to gyroid at 10%.  The parts came out very nice with good build plate adhesion and strength.

  8. I used painted seams for some areas as PS wasn't placing them all on the bottom of the part.  But PS also does some weird slicing that creates addition seams that I couldn't get rid of where the printed part gives way to the rail as the wedge gets smaller. 

  9. The center piece gets very thin towards the skinny end of the ramp.  Eventually, it's printed at a width of 3, then 2, then 1 pass and you can definitely see these change.  A more capable person may wish to end piece before it goes that far.  The part between the rails doesn't serve much purpose once the rails are sufficiently exposed. 

Happy printing and train-ing!

Tagi