Mesa 7I97T & 7I74 din rail mount

I am doing a Maho MH 600W retrofit to Linux CNC and wanted to make a din rail mount that stacked the Mesa 7I97T on top of the Mesa 7I74 with the ribbon cable going between.

The model has a top and bottom model because the 7I97T does not have symmetrical hole locations, but can still be flipped upside down if you desire by swamping the din rail mount around. With the fixed groove on the top with the though that if the spring groove breaks it will still stay attached.

The orientation of Top meaning writing is in the correct orientation when the board is on it side.

The screw into the "bottom" bracket of the 7I74  little bit of a pain to get in as the second hole location between 7I97T and 7I74 are slightly off, that is why I didn't use standoffs for those holes. 

Hardware used:

• 2 - M3x20 & M3x10 standoffs combined together

• 12 - M3x6mm screws

Used this standoff kit https://www.aliexpress.com/item/1005008660377268.html

Din Rail Bracket:

I printed in PETG but had 4 brake right in the spring part of the mount, so change to a different filament and had no issue with many attach and deattach to a din rail

din rail bracket from printables din-clip-redux-unibody-simple file modified in fusion to fit the width of the of the board 

 https://www.printables.com/model/472505-din-rail-bracket-redux