1 / 2
Könighaus Infrarotheizung Standfüße — zdjęcie 1
1 / 2

Könighaus Infrarotheizung Standfüße

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ersatz für die anschraubbaren Standfüße mit Rollen

Ocena
0 / 5
Polubienia
1
Pobrania
25
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Da die  standartmäßig anzubringenden Rollfüße der Könighaus Infrarotheizung sich bei jedem kleinsten hin und her Bewegung automatisch verabschiedeten habe ich als Ersatz diesen Standfuß designed in dessen mittiger Öffnung sich die Heizung einfach hineinrutschen lässt. Das Teil wird zwei mal gedruckt (am besten aus ASA/ABS oder einem ähnlich hitzebeständigen Filament) und dann auf den beiden unteren Enden der Heizung aufgesteckt. Die Aussparung in der Mitte ist mit einer minimalen Toleranz von 0.6mm entworfen  und für eine Heizungsdicke von 18mm entworfen.

Aufgrund der großen Auflagefläche empfiehlt sich im Zusammenhang mit ASA oder ABS ein zusätzliche Sprayfixierung für das Heizbett zu verwenden da eine ein Rand alleine oftmals nicht in der Lage ist den Verzug des Teils zu verhindern.

Ich habe für meinen Druck ein 0,20mm Schichthöhe und ein 15% Bienenwaben Infill Muster verwendet.

English translation:

Since the standard roller feet that come with the Könighaus infrared heater would automatically detach with the slightest back-and-forth movement, I designed this stand as a replacement, into whose central opening the heater can simply slide. The part is printed twice (ideally from ASA/ABS or a similar heat-resistant filament) and then attached to the two lower ends of the heater. The recess in the middle is designed with a minimal tolerance of 0.6mm and for a heater thickness of 18mm.

Due to the large contact surface area, it's recommended to use additional spray adhesive for the heated bed when working with ASA or ABS, since a brim alone is often unable to prevent warping of the part.

For my print, I used a 0.20mm layer height and a 15% honeycomb infill pattern.

Tagi