Stormcast Eternal hammer

I used measurements from the actual miniature to make the hammer, it can be printed easily without any support material if your machine has decent cooling fans. It is designed to use two 1/4 inch steel rods to line each part up and give strength to the handle portions. Printing is very easy, the only issue is the stars tend to warp, so I would recommend adding a brim. "stars2" is a thicker version of the stars that lets the details stick out so that there isn't a dip where the hammerhead meets the base. The handle is the tallest part at 278mm, and the widest part is head3 at 197mm, so plan, cut and scale according to your printer. I have yet to sand and paint this, but it certainly is large after assembly. The entire length of the hammer is 28" or 71cm. I uploaded an unscaled version of the hammer that would fit a miniature and an uncut scaled version if you wanted to cut it yourself. I'll update all of this as I work on finishing this project and upload a photo of the assembled hammer.