1 / 3
ASRock AMD BC-250 Shell Case w/ 40mm SSD Fan — zdjęcie 1
1 / 3

ASRock AMD BC-250 Shell Case w/ 40mm SSD Fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adds a 40mm fan to move air over the SSD

Ocena
0 / 5
Polubienia
6
Pobrania
29
Wydruki
0
Wyświetlenia
1991
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

I saw a comment on the original make that the hot air is dumped out over the SSD.  I added a 40mm fan to bring in cool air to hopefully counteract that.   This uses 4 M3 heat inserts and 4 M3 screws to secure the fan to the case.  The wire can be run outside the case or through the inside for a cleaner look.  I used a 12v 2 wire fan that I wired directly to the LOP-300 powering my board so it runs full speed all the time, but I suppose you can also find a way to wire it into the main fan as well.  You can add a fan guard as well if you're afraid of fingers getting too close.

Printed using the same parameters as the original model.   No supports needed but the top curve of the fan hole will droop slightly.  Not a big deal as it will be hidden behind the fan anyway.

This is just a remix of the front shell.  For the rear shell and all other parts please use the original model.

Tagi