1 / 2
Sovol SV08 Max 150mm ZZ Tophat - 2 x Fan — zdjęcie 1
1 / 2

Sovol SV08 Max 150mm ZZ Tophat - 2 x Fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Sovol SV08 Max 150mm ZZ Tophat replacement corner for moving the enclosure fans to the side, or just add 2 more.

Ocena
0 / 5
Polubienia
3
Pobrania
21
Wydruki
0
Wyświetlenia
192
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is an addon to the Sovol SV08 Max 150mm ZZ Tophat 



Replacing a corner with a version that so you can place two 120mm fans on the side usefull if you want to move the enclusure fans so the printer can be closer to a back wall.

This model uses 8x4mm inserts for the fans all other holes do not and are just printed slightly smaller to allow threded screws to fit nicely.

A great care was made to be able to print without much support, so hopefully "Automatic support" would be good to go, at least maybe with my setting below.

I print this with Ocra slicer using:

Quality

  • Wall generator

    • Wall generator - Arachne 

Support tab

  • Enabling support,

    •  "Tree (auto)" 

    •  Threshold angle: 20 dgr

    •  Remove small overhang

  • Advanced

    • Top Z distace 0.34  (for more easy removal, you might want to test/tune this)

    • Bottom distace 0.34  (for more easy removal, you might want to test/tune this)

With this I printed the 4 big corners as then normaly stand and Ocra only adds support for the first few mm to the first edge and some support for the glas holder slider cut ins.

Notable other setting is that in Quality tab I use Bridge flow rate:  1.75 and my filement setting has 100% fan on "Overhangs and external bridges fan speed" this is to make overhang/bridges more nice, not sure if it strictly needed for this print.

Warning: This is a large print and made to be printed on the SV08 Max itself to keep number of pieces down.  E.g. some part probably need an print area of about 360x360 and even lager for the IKEA Förnuftig addond e.g 470x360

Link to CAD files:
https://cad.onshape.com/documents/017be025acd33fb5c4a610f1/w/99d8c6f61eba4f77f98a66d0/e/680cb076dd87bd3e6a5822c2?renderMode=0&uiState=69622db234b872f316faa131

Version history:
V22 2026-01-24 First version 
V29 2026-03-02 Add 0.3mm space around top glass

Tagi