X carriage for E3D Hemera on LeapFrog Creatr (Or other 60 mm rod distance 8 mm rod printer)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bearing holders mount to side of hemera, belt, cable guide and fan mount to front bearing holder. For LM8UU or RJ4JP0108
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
X cariage for E3D Hemera on LeapFrog Creatr (Or other 60 mm rod distance 8 mm rod printer)
Bearing holders mount to side of hemera, belt and cable guide and fan mount to front bearing holder.
The Creatr uses 8 mm rods, 60 mm apart. The rods on Mendel90 are also 60 mm apart (But I used 10 mm rods there). Other printers might also have their X-axis rods 60 mm apart so this might fit other printers as well.
Endstop hits fan on the side of the housing, not on the blades. One could mount it with the back to the endstop, but then the hotend covers a non-heated side of the bed while leaving a heated part of the other side unreachable. So it is better to mount it this way.
Print in PETG or something sturdy yet flexible. Use organic supports for front bearing holder. Place bearings, place M4 nuts for belts (or test fit them to place in situ), place m3 nut for fan mount. Then mount to hemera with m3x8mm bolts. Take care not to use too long bolts as that could break hemera (see hemera manual).
Then mount on printer (remove a side panel, undo the 2 screws holding the alu plate over the rods, remove plate, remove rods, place new carriage, reassemble printer)
It uses 3 bearings type LM8UU or RJ4JP-01-08, 4 bolts & nuts size M4 for the belt with alu plates from printer, 8 bolts size M3x8 to mount to hemera with the square nuts from the Hemera, 3 bolts&nuts size m3 to mount the cable guide and fanmount.