Pelco DSSRV/DSSRV2 Rack Ears with Pull Loops
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Happened upon a DSSRV case without ears and I didn't want to buy them, so I made some instead.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Designed it around my DSSRV, should fit the DSSRV2 because as far as I can tell they are the same exact case with the same exact part numbers for the rack ears and everything. I also made these to be a close fit to the standard 17.75" opening of a 19" rack.
Any material is fine, no special settings either. Orientation is with the loop flat on the build plate. You may or may not need supports, just go with what your slicer wants to do.
"Rail" version is intended for my drawer slide system to allow the use of longer slides to pass through the ears, if you are not using this you should print the "normal" version.
Requires 2x or 4x M3 screws per ear (so 4-8x total) to attach it to the case, normal version is 4, rail version is 2, and they can be 8mm to 12mm long.
F3D and STEP files included for ease of remix.