Duct Tape (Duck Tape) Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A dispenser for keeping things away from the sticky sides of duct tape and helping cuts with a blade.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 271
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this dispenser to prevent everything sticking to my roll of duct tape while I was using it :)
Materials needed
2x M3 brass inserts
2x M3 screws, shorter than 7mm
1x M4 brass insert
1x M4 screw, shorter than 7mm
Blade from a foil cutter or a piece of thin sheetstock cut to shape
Instructions
Turn on "supports everywhere" when printing or the slot and tab at the back will not work properly.
For the blade, I used the serrated blade from a box of aluminium foil. It had spikes to stick to the cardboard, so those got flattened with a punch. Then I cut a couple of notches roughly in the area the screws would pass through.
