Ultra-Compact Dual 1/4” Screw Cold Shoe Adapter for SmallRig and Other Cages
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ultra-compact dual 1/4”-20 cold shoe adapter with captured screws for SmallRig cages and tight camera builds.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
This is an ultra-compact cold shoe adapter designed specifically for SmallRig camera cages and accessories. The design prioritises minimum size, clean mounting, and secure screw retention, making it ideal for tight camera builds where space is limited.
The adapter measures just 39 mm wide × 22 mm long × 10 mm thick, while still supporting a standard cold shoe mount and dual 1/4”-20 mounting points. The screws are fully captured inside the model, meaning they do not fall out during installation or removal.
Two design variants are included:
V1 (Non-Angled) – A more box-like design with a simple, robust shape.
V2 (Angled) – Features an angled rear profile for reduced size and weight, while maintaining the same functionality and durability as V1.
Both versions are fully compatible and perform identically in use; the choice is purely based on space constraints and aesthetic preference.
Multiple print-ready files are included to support different print orientations depending on your printer and material. The angled vertical cold shoe file is recommended for the best balance of strength, accuracy, and surface finish.
Key Features
Ultra-compact footprint – only 10 mm thick
Dual 1/4”-20 mounting for excellent stability
27 mm screw spacing, compatible with SmallRig standards
Captured screws – screws stay in the part and don’t fall out
Clean, low-profile design ideal for cages, handles, and rails
Designed for easy DIY assembly
Specifications
Overall size: 39 mm × 22 mm × 10 mm
Screw type: 2× 1/4”-20 × 6.3 mm
Screw spacing: 27 mm (centre-to-centre)
Mount type: Cold Shoe
Assembly Instructions
The adapter consists of three printed parts:
1× main cold shoe mount
2× retaining rings (top caps)
Assembly steps:
Insert the two 1/4”-20 × 6.3 mm screws into the main plate from below.
On a new print, you may need an Allen key to initially move the screws.
Tighten each screw until the thread below feels “stripped”.
This is intentional and important — it allows the screws to remain mostly free-spinning while still being retained.
Once both screws move freely, apply a small amount of CA glue to the two retaining rings.
Press the rings into place to lock the screws permanently inside the adapter.
Allow the glue to cure fully before use.
If any glue seeps onto the screws, use a Alan key to tighen the screws to loosen them and wash the print want running water to remove access dryed glue.
Once assembled, the screws will remain captured and ready for mounting without falling out.