1 / 1
Flag pawn for board games (no glue, no supports required)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flag pawn for board games
- Ocena
- 4,667 / 5
- Polubienia
- 24
- Pobrania
- 185
- Wydruki
- 4
- Wyświetlenia
- 740
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 4) (Komentarze: 7)Remiksy (0)Kolekcje (49)Powiązane
Flag pawn for board games printable without supports (2 pieces).
After print, put flag into the stand. No glue required as it is quite tight.
Print without supports. There are 2 pieces, stand and flag.
I use ironing for better look (Prusa Slicer - Print Stttings->Infill->Ironing).
Less than 0.7 meter of filament used. So if you have remains of filament on the spool and you do not know what you can print from such a piece, this is for you :)