LayersFactory
Zgłoś model
1 / 2
Toothless figurine — zdjęcie 1
1 / 2

Toothless figurine

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Kategoria
Other Art & Designs
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives
SzczegółyWydruki i komentarzeRemiksyKolekcjePowiązane

mine came out poorly due to support being as light as the dragon so here are the tips

what I used:

  • Printer: FlashForge Adventurer 5M

  • Scale: 76 mm (X) × 81 mm (Y) × 30 mm (Z)

  • Final Size: ~3 inches tall

Recommended Settings

  • Layer Height: 0.2 mm (0.16 mm for extra detail)

  • Infill: 10–15% (model is decorative and lightweight)

  • Shells/Walls: 2–3 walls

  • Supports: Yes

    • Use auto supports

    • Support overhang angle: ~50°

  • Build Plate Adhesion: Brim recommended (small footprint)

 First Layer 

  • Print the first layer slowly

    • First layer speed: 15–20 mm/s

  • Make sure the bed is clean and properly leveled

  • Slightly increase first-layer extrusion if needed

 Temperature (PLA)

  • Nozzle: 200–210 °C

  • Bed: 55–60 °C

 Print Time

  • Approximately 3–4 hours, depending on layer height and speed

Notes

  • Model is non-articulated (limbs do not move)

  • Designed for decorative use

  • Prints lighter than larger dragon models

  • Light sanding can help smooth support contact points

  • built in eyes

Tagi

dragondragondecordragondecoration