Elegoo Neptune 2 X Axis Extruder Chain
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Due to the the solid top of the on the extrusions for the Neptune 2 and differing geometry for the extruder plate,…
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 63
- Wydruki
- 2
- Wyświetlenia
- 502
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Due to the the solid top of the on the extrusions for the Neptune 2 and differing geometry for the extruder plate, there wasn't a good way to attach the cable chain for the x axis and extruder wires.
The back mount simply replaces end cap of the extrusion, print with the channel side down. The ribs in the channel are there to help with bridging so you shouldn't need supports.
The extruder mount piece mounts to the bottom of the extruder plate. I use zip tie to hold it on through the hole between the extruder and the filament sensor. The screws from my filament sensor also extend slightly below the metal plate and can be screwed into the small holes on the chain mount for some extra security, or some double sided tape or longer screws with nuts could be used. There's also a couple of extra holes for a zip tie to secure the hot end wires.
Print off the chain links and clips from the base design. I believe I used 22-23 links and clips, there's also spots on the mounts here for a couple of extra clips. I did have a couple links flipped backwards on each end connected to each mount to help the with the bending direction
Print Settings
Printer:
Neptune 2
Rafts:
Doesn't Matter
Supports:
No
Resolution:
200
Infill:
15
Filament:
Hatchbox PLA
White
Category: 3D Printer Accessories