Dorfromantik Sakura Flags (Banners) - Single Color or Multi Color

These banners are based on a design by GWGumby, but decorated, and improved for multi-color printing.

The most noticeable changes are the thinner banner, and the border around the banner. You can choose to print the border in a different color, or as a simple groove, or leave it filled in (invisible) if you don't like it.

Printing Instructions

Print all parts in the default orientation. For the whole campaign you will need 3 flags of each color and 1 three-colored flag (sorry for the minor spoiler).

There three ways to color the models:

• Pre-colored:

  • Use the pre-colored .3mf file for Bambu Studio (easiest)

• Manual:

  • Load one of the files that have "multipart" in the file name

  • Then right click the object, and select "Split" and then "Split to parts".

  • Go to the "Objects" tab and assign colors to the individual parts

• Paint tool(NOT RECOMMENDED!)

  • You can use the paint bucket tool in OrcaSlicer or Bambu Studio to color the parts.

  • This will cause strange artifacts inside the flagpole, at least in Bambu Studio.

  • Don't do this.

Assembly Instructions

• Place the base on the table

• Hold the flag lightly in the hole in the base (in the correct orientation)

• Give the flag a light tap with a small hammer or some other light object, like piece of wood

• The flag should click into place and hold firmly. No glue necessary.

• If the flag does not go in after a few light taps, try printing the base 1-2 percent larger.

Also available on Thingiverse: https://www.thingiverse.com/thing:6920295