Coffee dosing funnel and tamper for 51mm Delonghi
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dosing funnel for a 3-lug 51mm Delonghi portafilter. Includes small tamper that fits through the funnel.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 61
- Wydruki
- 2
- Wyświetlenia
- 261
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
This is designed to fit a 3-lug portafilter with a 51mm ID and a 62mm OD. It is held in place by 8 5mm(dia)x3mm(thick) magnets. The magnets friction fit in the holes and are installed after the print is finished. They're cheap and readily available if you search for "5x3 magnets" wherever you buy things online. The stainless basket on the portafilter is just magnetic enough to hold it in place, but not enough to pull the magnets out of the holes.
The funnel keeps the grounds from going all over the counter when you pour them in from the grinder, but then there's a heap of fluffy grounds so you can't take the funnel off. To take care of that, I designed a tamper that fits through the funnel so you can tamp, then remove the funnel. The tamper is short so it fits easily in any drawer. I also used fuzzy skin for the handle when I printed it. That's up to you if you want to do it.
Material: Whatever you want. I used PLA.
No supports - print the funnel with the magnet holes facing up
15% infill
I printed the funnel with 2 walls and the tamper with 4 just for a bit of extra strength. It probably doesn't matter. You shouldn't be pushing on it that hard.
