iPod Classic Moonlit Market Classic Connect 2 back panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't like the plastic back panel supplied with the kit, so I designed this to preserve the most of the metal back.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 657
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Open Community License v1
Compatibility
I tested it with an iPod Video, thick back. In theory it should work with any iPod with a thick back compatible with the Classic Connect 2 kit.
Tested with iFlash dual microSD adapter and a battery advertised as 2000 mAh, although I expect it to work with a somewhat bigger battery and/or card adapter.
To consider before printing
I haven't tested the wireless charging, cause I don't need it. I'm pretty sure it won't work with a metal back.
Button/slider caps are designed for resin printing
Depending on the battery used, wiring, filament type, and other things, the model could fit imperfectly. Expect some sanding for the best results.
BOM
Heat inserts and screws may be reused from the kit
The glue supplied can also be used, otherwise B7000 or whatever will hold plastic and metal together
1x lock_slider.3mf
1x bluetooth_button.3mf
1x top_cover.3mf
Preparations
Disassemble the kit. Unsolder the battery, wireless charging module, remove everything from the back panel.
If reusing the heat inserts, remove them from the case.
Refer to the Classic Connect 2 assembly manual to trim the metal frame and the top clip of the front panel. Or just measure it as you go.
Assembly
Cut about 12mm from the top of the metal cover. The actual measurement may vary slightly.
Put heat inserts in the printed part.
Put the slider/button covers, put the PCB and check fitment. You might need to sand the covers slightly.
When everything fits and clicks, glue the haptic module. Then screw the board to the cover.
Check how the plastic part fits to the metal. Sand if necessary.
Before glueing, scratch the metal surface to improve adhesion. Then proceed applying the glue.
Attach the ribbon cables, solder extra sync wires, if used.
Click the back cover in place.
Optional: Insert a 3-5mm of transparent filament to the small hole next to the USB C port. This is for the Bluetooth indicator light.
Optional: I found it easier to assemble the whole thing before applying slight pressure for the time the glue cures. This works well for the B7000 glue I got with the kit.
Is it a remix?
I was drawing inspiration from the following model, which is amazing, but the design is 100% from scratch.