Pipboy 3000 - CRT Like Display Lens
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Make your flat LCD display look like a proper CRT display for the Pipboy 3000 by jeje95
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 275
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Share Alike
Note: This is intended to be resin printed and clear coated for clarity. You can FDM print this, but it will take you a lot more post processing to get this 'glass like', which is necessary if you want a functional Pipboy 3000.
This MAY fit other 3D Pipboy models, but it was specifically designed to fit the model by jeje95
Post Processing
The best method I've found is as follows;
Print your model, and clean off any excess resin with IPA thoroughly.
Cure your model as usual. The combination of the IPA wash and the curing will cause it to be cloudy.
For finishing, I generally sand up to 2000 grit and the clear coat and use a polish.
Printing Tips
These worked for me, and may or may not work for you in other words; YMMV
My printer: Mars 5 Ultra
Resin: Elegoo ABS-Like v3.0 Translucent (again, this is what worked well for me)
Supports: Auto, Normal Density, Medium Strength (don't go stingy and try to save post processing time, you'll end up with a goopy mess on your FEP sheet and 2 hours wasted)
Position: I went for around a 45 degree angle. This was to reduce layer lines and simplify sanding. No matter what, you WILL need to sand. But hey, lets make life easier.
