Low D Whistle Thumbrest
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stablize C♯ on your whistle with a thumb rest.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 45
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Public Domain
A little thumbrest for your low D whistle. It will also keep your whistle from rolling off the table when you go for your glass of beer :)
I printed in PLA at 15% infill. No supports are needed if you put the top against the build plate. I used a tiny bit of poster putty on each side (where the ears would go in the helmet) to keep it in place.
I'm including two 3mf files. The 25mm inside diameter worked well for all my whistles, but you can fine-tune it by either scaling the model, or using your slicer to remove a cylinder of the exact diameter you need from the smaller 20mm model. Of course, you could always edit the OpenSCAD source, if that's the sort of thing you're into.