Elegoo Centauri Carbon Silencer + Filter --> FIXED
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Silencer + filter insert for Elegoo Centauri Carbon
- Ocena
- 5 / 5
- Polubienia
- 63
- Pobrania
- 326
- Wydruki
- 2
- Wyświetlenia
- 1895
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I fixed lance's models issues mentioned in the comments:
Closed the hole
Leveled the outer surfaces to reduce the amount of support material needed
Print instructions:
Turn supports on
Print with it's back on the plate
Use PETG or some other heat-resistant material, no PLA, since it might deform from the exhaust heat
2 walls and 10 % infill are sufficient
Use at least 3 bottom shell layers to make sure everything is airtight after removing the supports
Takes about 200g of filament and 8h to print
I use it with a few layers of generic filter fabric with active carbon, that's the cheapest option. 4 x 4 inch / 100 x 100 mm square filters should also fit.