Anycubic ACE Pro Extended Interface Plate (4-Pin + 6-Pin + USB-C)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a custom-designed interface plate for the Anycubic ACE Pro filament system.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 263
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a custom-designed interface plate for the Anycubic ACE Pro filament system. I created this "Extended" version to add a USB-C port to the rear of the unit, providing a clean solution for extra connectivity.
It is the perfect mod for those running Klipper-based firmware (like BunnyACE or DuckACE)
Features
Dual Connector Support: Precision-fit cutouts for the original 4-pin and 6-pin connectors.
Integrated USB-C Port: Specifically added to allow for external data or power access via a USB-C breakout board.
Direct Fit: Designed to align perfectly with the factory mounting points on the back of the ACE Pro unit.
Sleek Design: Features countersunk screw holes for a flush, professional finish.
Print Settings
Sacrificial Support Layer: The model includes a built-in sacrificial layer for the screw holes and the connector hole. This allows you to print the countersinks cleanly without needing slicer-generated supports. Simply poke through the thin layer with a screwdriver after printing.
Material: PETG, ABS, or ASA recommended. Since the ACE Pro features an active heater for filament drying, PLA is not recommended as it may soften or warp over time.
Orientation: Print face-down for the best surface finish.
Perimeters: 3 for better durability around the mounting points.
Hardware Requirements
Original Chassis Screws: Use the stock screws to fix the plate to the ACE Pro unit.
M2 Screws: Required for mounting the USB-C breakout board to the plate.
1x USB-C Panel Mount/Breakout.