Riser v.2 & v.3 is only for Creality K2Pro with glass.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Riser v.2 & v.3 is only for K2Pro with glass.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 74
- Wydruki
- 1
- Wyświetlenia
- 441
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Standard Digital File License
This is a refinement of the previous version of my Riser
Corrections:
- increased ventilation area by 50%.
- the design of some facets has been slightly tweaked to closely resemble the design of the K2 Pro.
- the connection tolerance has been corrected from 0.3 to 0.28.
- The connecting horizontal bar has been slightly lowered.
Recommendations:
- Use a 15% "Gyroid" filling.
- Use a layer thickness of 0.16mm, the bends will be much smoother.
- Use the frame of the part and the stand in only two places for the "dovetail".
- before removing the part from the hot table, be sure to wait until the table cools down, this will eliminate the deformation of the part and give a good result when separating from the curb.
- Use a set of dovetail fillers to remove the remnants from the support.
- It is advisable to use plastic glue for the connection, the design will become more reliable.
//13.02.2026//
A modified version of v.3 has been added.
Unfortunately, the design suffered here (platforms are visible under the glass from above in the corners, and the stops themselves do not look visually attractive in the center), but emphasis was placed on the reliability of glass support with CFS. (especially those who use weights in coils).
- The entire structure has been reinforced.
- Added additional glass support stops in the middle.