Alex Drawer Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1cm thick Alex Drawer Feet installable with screws
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
I bought OG Alex Drawers which came with holes for feet and sturdy feet, a year or so later I went to buy another Alex Drawer but after installing it, I discovered the quality wasn't the same, and the feet where just stuck using double side tape!
I lived with ti for a few years, but then I decided it is time to fix the situation after 3 feet got out of place and the drawer starting being warped.
I designed this feet to be 1cm thick, to match the OG Alex Drawers, the ones with good quality. This way i can put a table top and it will be straight.
This design uses screws to ensure it is sturdy and does't come off with pushing and pulling across floors
Hope this helps someone, somewhere!
P.S.: I discovered later that I had to widen the screw holes a little bit, but I guess printing them tight and widening them with a knife head is better than printing wide and having to reprint :D.