1 / 3
Shelly Gen4 DIN rail mount with space for 6 WAGO 221 clamps — zdjęcie 1
1 / 3

Shelly Gen4 DIN rail mount with space for 6 WAGO 221 clamps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a fully optimized DIN mount with space for up to 6 WAGO 221 clamps to keep things organized.

Ocena
5 / 5
Polubienia
12
Pobrania
118
Wydruki
1
Wyświetlenia
683
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

This model is designed to hold one shelly of generation 4 (may be some of gen3 are fitting, too). The shelly is held in place and can never fall of. Just put it in and slide it to the front (down on my photo). After installing all cables he can never slide back. The wago 221 clamps are held by a click mechanism. You can safly uninstall them with a small screwdriver from the bottom of each clamp.

My first approach had fully closed channels for the cables, but there is not enough room in a standard DIN rail mount, which is only 17,8mm wide. My tip is to use ~8cm long cables (1,5mm²  - rigid strand just works fine, but you can also use flexible ones). One end of the cable can be connected to the right side of the WAGO 221 clamp. Then click the clamp in place. Guide the cable through the channel and through the hole. Cut it to the correct length and connect it to the shelly.

I did not put text like L, N, I or O on any clamp connector, because there are to many variations. In my example image I think it's a good idea to separate 12V DC and 220V AC. But in other scenarios there are other connections needed. I think the best idea is to mark your outlets using the cable color. As the cable sticks out a few millimeter on the clamp it's really easy to see.

A cable can be inserted or removed by just sligthly pulling on the lever of the clamp. So rearranging cables does always work, if there are other modules on the left or right.

The locking mechanism for mounting on the DIN rail is inserted in the center of the Shelly holder and then pushed downwards. It has two locking positions (open and closed) and can fall out downwards.

I printed mine on the bambu lab X1C with 0,12mm layer height without any supports or brims in default setting for this profile. Lay the module and the little clip down on the backside. The module is designed to be printed without any supports.

There is also a model variant for WAGO terminals with 6x3 connections. This one is 1,5 times as wide (26,7mm instead of 17,8mm).

Tagi