1 / 1
Low profile key cap for Gateron 2.0 low profile switches — zdjęcie 1

Low profile key cap for Gateron 2.0 low profile switches

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a keycap with 'loose' tolerances, should fit any Gateron 2.0 low profile switch.

Ocena
0 / 5
Polubienia
4
Pobrania
36
Wydruki
0
Wyświetlenia
292
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Public Domain

This is a simple keycap with 'loose' tolerance to fit snuggly in any switch, without using too much force.

I made it as a replacement for a board, where author used Kalih switches, which i swapped for Gateron Low profile switches. This limited me in dimensions, hence this keycap is actually rectangular (16.5 by 17.5)mm 

At this point i am not ready to fully publish my forked version, but as this is 'original' work i post it as is, other keycaps on this website were too 'snug' for my liking, and this keycap could be useful for your testing purposes.


Diameter of stem is 5.58mm, height is 3mm

'Cross' bars have length of 4.15 and width of 1.37mm 

Those dimensions are derived from 'worst case' tolerances of Gateron 2.0 low profile switches, and 0.1mm generic 3d printing tolerance 

Printing with 0.2mm layer height on lower speeds using PLA proved sufficient

Force required to insert and extract keycap are similar'ish to generic injection molded keycaps 

Tagi