TriV06 - TV06 triple z mod

Triple Z mod inspired by the Voron Trident with a magnetic bed mount solution from .GutterGames_CA.

Print in a stiff filled material such as ABS/ASA CF/GF.

BOM:

• 18x M5x10mm BHCS 

• 4x M4x8 BHCS

• 20x M3x12mm SHCS

• 2x M3x10mm BHCS

• 16x M3x8mm BHCS

• 15x M3x6mm BHCS

• 4x M4 washers 10mm diameter

• 18x M5 t nuts

• 20x M3 t nuts

• 2x M3 square nuts

• 330mm 2020 extrusion

• 250mm 2020 extrusion

• 1x M5x8mm (or 10mm) BHCS

• 2x MGN9H 300mm rails

BOM from the ball-and-magnet system:

• 3 x M4x12mm SHCS for the steel balls

• 3 x countersunk disc magnets measuring 11.4mm in diameter and 2.4mm in height with an M4 hole

• 3 x 10mm M4 threaded steel ball rod ends

Other parts needed (reuse or purchase additional ones):

• 3x NEMA17 motors, you'll need to source a third one if coming from the TV06, 3x leadscrews TR8x4 (2mm pitch, 4mm lead)  + couplers ~290mm
  OR

• 3x NEMA17 with integrated leadscrews

• 3x round TR8x4 leadscrew POM/brass nuts (2mm pitch, 4mm lead) 

• SV06 bed including carriage OR Voron Trident 250 bed

• 2x 8mm linear rods

• 2x LM8LUU linear bearings

Additional printed parts needed:

• Z front left and Z front right motor mounts either from the Voron Trident or this mod here if you want to use inverted electronics (https://mods.vorondesign.com/details/pXkXHVIUbqSWqQKJISczw) If you are using leadscrew couplers, you will need to mod the motor mounts by extruding the face that touches the motor by an additional 26mm and adjusting the screw holes accordingly; or

• Z_Left_Motor_Plate_Thick in the list below

Instructions

1. Print all the parts listed here + the Z front left/right mounts + z_bed left (+mirrored) + z_bed_rear from the ball and magnet mod. Where a part is labelled left, print the corresponding right-hand part by mirroring it along the X axis.

2. Install the motor + leadscrews using couplers (skip if integrated)

3. Install the motors on the corresponding mounts Z left/right (from Trident) + Motor Plate Back (from this page) using 4x M3x12mm screws each (12 in total)

4. Install the Z left and right mounts on the front corners of the printer using M5x10mm + M5 t nuts (4 for each motor, 8 total)

5. Loosely install the Motor Back plate on the rear bottom extrusion using M5x10mm + M5 t nuts (4x). You want it to be able to slide around for correct positioning.

6. Install the linear rails on the front vertical extrusions on the face which faces each other (this is different from how the Trident does it due to the lack of vertical space on the TV06) using M3x8 + M3 t nuts (8x each, 16x total)