Baby Mobile Crib-Mount and Floor Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These files can be used to to create both a crib-mounted baby mobile hanger and a floor stand for said hanger.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 2
- Wyświetlenia
- 265
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a floor or crib-mounted hanger for a baby mobile. It utilizes 5/8" wooden dowels of whatever length is required and a gear mechanism for adjustability at the joint.
Crib Mount Instructions
Print these parts:
Clamp
Clamp Screw
Joint Piece 1
Joint Piece 2
Joint Screw
Endcap
For all but the endcap, use high infill and extra walls.
Assembly is pretty straightforward, please refer to the photos to see it in completed form. You will need to cut 5/8" wooden dowels down to whatever length fits your needs. The clamp was designed to fit over a 20mm rim of a crib or changer, but it can fit slightly smaller or larger. Each piece has a hole for a small screw to fix the pieces to the wooden dowels, but I have found that with the right print settings, the fit is tight enough to do without those screws. When using the joint screw, it does not need to be threaded very tightly. Just thread it far enough into the joint to prevent the gear teeth from slipping.
Floor Stand Instructions
Print all of the same parts, plus these:
Floor Base
45 degree Foot extender (x2)
Foot (x2)
Make the base at least as long as the hanger arm to prevent tipping. See photos for assembly. I also paused the Floor Base print before the top surface was printed to add some sand into the infill, which helps with stability.