Ergonomic Snow Shovel Shaft Handle Add-on
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An ergonomic grip that can be added on to any shovel shaft for easier use and less sore backs.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 360
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
Printing Instructions
Profile: A high strength printing profile is required; I recommend at least 5 wall loops and higher density infill.
Supports Not Needed: Supports not required.
Filament Type: PLA worked well for me, but a filament with better temperature ranges and durability such as ASA or ABS might be even better.
Additional Materials
4x M3 Screws: Four screws to attach the handle to the backing clamp. depending on handle diameter, 30mm screws should be long enough for the "deeper insets" model. For the more durable, recommended model, approximately 40mm screw length will be required.
4x M3 Nuts: Four nuts that should fit in the clamp
Assembly Instructions
Place screws through handle and clamp around shovel shaft.
Before tightening, adjust to desired height and angle.
Tighten screws, alternating a few turns between all four to ensure they are approximately even.
Description
Save your back this Winter season with this ergonomic add-on snow shovel handle. Adjustable, and attachable to shaft diameters up to 30mm!