Veer Cruiser Cupholder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cupholders for Veer cruisers / wagons
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 1
- Wyświetlenia
- 274
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Veer's standard cupholders for their cruisers/wagons can barely hold a paper cup, while not fitting larger drinkware like from Owala or Fellow. Even if the diameter wasn't an issue, they freely pivot and can fully tip out your drink. They also must be removed when you fold the wagon.
These fit drinkware that's up to 80mm and 90mm in diameter, depending on the profile you pick.
I printed in PETG and would recommend the same.
Installation
Print the correct side you want a cupholder on (or both!)
Turn 90º with arms facing away from handlebars
Place mount’s wider opening onto the peg
Slide horizontally until you dead end
Swing the holder down until the arms start to hit the bar
Gently tilt back the whole holder so the inner arm can clear while pushing it over to help it all snap in place
What's new
‼ Offset holder from mounting clip so that its wall can be folded without removing the holder. Still gets in the way of the long side walls from folding (unavoidable) but at least now you can fold the handlebars
Tilted the holder 6º horizontally so that it accounts for the mount bar’s left-right tilt. Previously it only leveled out the front-to-back tilt.
Disconnected the arms from each other so that they can flex enough to be installed without a mallet
Bumped out tolerances by 0.1mm for easier installation & more forgiving print