AD5M LED Holder Clips for Amazon LED Bar

Additional Items Needed:

Magnets

https://www.amazon.com/dp/B0CCXY6WBR?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

https://www.amazon.com/dp/B0CDH2HCV9?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1 

LED Bar

https://www.amazon.com/dp/B0F8H61JTK?ref=ppx_yo2ov_dt_b_fed_asin_title

Print this and install it on the middle horizontal bar on the right side on the printer. It is the same chase that is used for the ribbon cable of the LCD. I chose to install it on this side only, because that is the side that has the camera on it. My thought was that if I added another one on the other side, it would wash out the image.

Print out two the the clips and insert 2 magnets into each clip. and slide the clips on the LED bar from the side without the connector. The magnets will be oriented to be up and to the right with the LEDs facing left. Then feed the wire into the back of the unit via the LCD ribbon cable chase. Once all the wire and part of the back of the LED bar are inside the unit, you will be able to start to place the LED bar. The back mount will sit in the back notch of the chase and then you can position the LED bar along with the front mount to the notch in the middle of the chase.  Be sure to be clear of the gearing for the bed by making sire the LED board is not past the back of the front-most notch.

Then remove the panel screws from the back of your unit and install the wire to the 24v JST connector on the bottom left of your mother board.

If you have any questions, please feel free to reach out.