Adafruit SCD-41 / SCD-40 CO2 Sensor Enclosure/Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an enclosure for the Adafruit SCD-41/SCD-40 CO2/temperature/humidity sensor board with a detachable lid.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 301
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is an enclosure for the Adafruit SCD-41/SCD-40 CO2/temperature/humidity sensor board with a detachable lid and holes for attaching magnets (⌀ 6mm) on the bottom.
There are two versions of the case: One with a bottom hole to access the pins and one with side access to the I2C port.
The lid screws down through the vent holes and then through the four corner holes in the board. For additional stability I screwed some standoffs on top of the sensor board and then screwed the lid onto the standoffs. The screw holes are M2.5.
I have only tested this with a SCD-41 but it should fit the SCD-40 as well. Tolerances are quite tight so you might want to scale the model up a touch.