Nsr250 Mc21 Pgm3 Rubber Grommet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
GR2 grommet for the PgmIII ignition Unit.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 78
- Wydruki
- 1
- Wyświetlenia
- 378
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the “GR2” rubber grommet that along with a metal bushing and a screw, keeps the PGM-III unit in place.
A suitable material for the application is TPU (thermoplastic polyurethane), a flexible filament with excellent vibration-damping properties, high toughness and chemical resistance. The grommet will be a little bit stiffer than the OEM part, so if you wish you can use TPE filament instead.
Please, tune your printer with the below settings for optimal results :
Plater :
Print Settings : 0.15mm Quality
Filament : SainSmart TPU
Supports : Everywhere
Infill : 10%
Layers and Perimeters :
Perimeters : 1
Solid layers, Top & Bottom : 5 & 4
Infill :
Top and Bottom fill pattern : Concentric
It is also possible to print the grommet on its side with a small portion chopped off, as to provide a flat print surface and NO supports.
TPU will stick extremely well to the PEI sheet, do NOT omit to use kapton tape or glue stick on the surface.
Have fun
Nick