Chomper (Pacman inspired) Model with base No AMS

A pacman inspired model (this is not a storage jar though) I made to go with the ghost model storage jar

There is also a moneybox version of this Pacman model and a moneybox version of the ghost

When preparing the eys I suggest you file and sand all the bottom edges, then glue the little yellow inserts in the eyeball, let it dry and repeat, then push the assembled eye through the model a few times (it may be stiff) and it will loosen up after a few goes, if you want to glue the whole eye in (I didn't bother was tight enough not to fall out) DO NOT use superglue as it dries too quick and if you misalign it you won't get a second chance! use epoxy.

Will print with no supports.....just. Just make sure you slow your printer down sufficiently for the overhangs.

I strongly suggest using adaptive layer heigt of 0.3 and smooth about 7 times in Orca Slicer to get the head smooth on the top. I also bridged the top, but you could also use support (I didn't)- you would only need it in the middle of the head, the eye sockets print fine with no support.